More actions
This is the page for using the 3d-Printers in the Pixelbar.
Printers[edit | edit source]
Ender 5[edit | edit source]
Owner: Pixelbar
Warden: Sir 16-Bit
Expert Advisor: FPoison
Mods[edit | edit source]
[a lot]
Instructions[edit | edit source]
Startup:
- do auto z-level
- check tramming (paper between nozzle and bed)
- Use profile from wiki
Other instructions:
- Start print from octoprint (SD card does not work)
- PETG may only be printed on the bare steel side of the buildplate
Todo[edit | edit source]
- install pi
- testprint
- Upload profiles to Wiki