View source for Archive:3D-Printing



This is the page for using the 3d-Printers in the Pixelbar.

= Printers = 
== Ender 5 ==

[[File:ender5_pixelbar.jpg|200px|thumb|right|The Ender 5]]

Owner: Pixelbar

Warden: Sir 16-Bit

Expert Advisor: FPoison


=== Mods ===
[a lot] 

=== Instructions ===

Startup:
* do auto z-level
* check tramming (paper between nozzle and bed)
* Use profile from wiki

Other instructions:
* Start print from octoprint (SD card does not work)
* PETG may only be printed on the bare steel side of the buildplate


=== Todo ===
* install pi
* testprint
* Upload profiles to Wiki