Difference between revisions of "3D-Printing"
Jump to navigation
Jump to search
Sir 16-bit (talk | contribs) |
Sir 16-bit (talk | contribs) |
||
Line 3: | Line 3: | ||
== Ender 5 == | == Ender 5 == | ||
− | [[File:ender5_pixelbar. | + | [[File:ender5_pixelbar.jpg|200px|thumb|right|The Ender 5]] |
Owner: Pixelbar | Owner: Pixelbar | ||
Line 11: | Line 11: | ||
Expert Advisor: FPoison | Expert Advisor: FPoison | ||
+ | |||
+ | === Mods === | ||
+ | [a lot] | ||
=== Instructions === | === Instructions === |
Revision as of 12:01, 25 February 2022
This is the page for the 3d-Printers in the Pixelbar.
Contents
Ender 5
Owner: Pixelbar
Warden: Sir 16-Bit
Expert Advisor: FPoison
Mods
[a lot]
Instructions
Startup:
- do auto z-level
- check tramming (paper between nozzle and bed)
Other instructions:
- Start print from octoprint (SD card does not work)
- PETG may only be printed on the bare steel side of the buildplate
Todo
- install pi
- testprint