Difference between revisions of "3D-Printing"
Jump to navigation
Jump to search
Sir 16-bit (talk | contribs) |
Sir 16-bit (talk | contribs) |
||
Line 20: | Line 20: | ||
* do auto z-level | * do auto z-level | ||
* check tramming (paper between nozzle and bed) | * check tramming (paper between nozzle and bed) | ||
+ | * Use profile from wiki | ||
Other instructions: | Other instructions: | ||
Line 29: | Line 30: | ||
* install pi | * install pi | ||
* testprint | * testprint | ||
+ | * Upload profiles to Wiki |
Revision as of 12:01, 25 February 2022
This is the page for the 3d-Printers in the Pixelbar.
Contents
Ender 5
Owner: Pixelbar
Warden: Sir 16-Bit
Expert Advisor: FPoison
Mods
[a lot]
Instructions
Startup:
- do auto z-level
- check tramming (paper between nozzle and bed)
- Use profile from wiki
Other instructions:
- Start print from octoprint (SD card does not work)
- PETG may only be printed on the bare steel side of the buildplate
Todo
- install pi
- testprint
- Upload profiles to Wiki