Difference between revisions of "3D-Printing"
Jump to navigation
Jump to search
Sir 16-bit (talk | contribs) |
Sir 16-bit (talk | contribs) |
||
Line 1: | Line 1: | ||
− | This is the page for the 3d-Printers in the Pixelbar. | + | This is the page for using the 3d-Printers in the Pixelbar. |
+ | = Printers = | ||
== Ender 5 == | == Ender 5 == | ||
Revision as of 12:03, 25 February 2022
This is the page for using the 3d-Printers in the Pixelbar.
Printers
Ender 5
Owner: Pixelbar
Warden: Sir 16-Bit
Expert Advisor: FPoison
Mods
[a lot]
Instructions
Startup:
- do auto z-level
- check tramming (paper between nozzle and bed)
- Use profile from wiki
Other instructions:
- Start print from octoprint (SD card does not work)
- PETG may only be printed on the bare steel side of the buildplate
Todo
- install pi
- testprint
- Upload profiles to Wiki