3D-Printing
Revision as of 11:55, 25 February 2022 by Sir 16-bit (talk | contribs) (Created page with "This is the page for the 3d-Printers in the Pixelbar. == Ender 5 == Owner: Pixelbar Warden: Sir 16-Bit Expert Advisor: FPoison === Instructions === Startup: * do auto z...")
This is the page for the 3d-Printers in the Pixelbar.
Ender 5
Owner: Pixelbar
Warden: Sir 16-Bit
Expert Advisor: FPoison
Instructions
Startup:
- do auto z-level
- check tramming (paper between nozzle and bed)
Other instructions:
- Start print from octoprint (SD card does not work)
- PETG may only be printed on the bare steel side of the buildplate
Todo
- install pi
- testprint