3D-Printing

From Pixelbar Wiki
Revision as of 10:59, 25 February 2022 by Sir 16-bit (talk | contribs)
Jump to navigation Jump to search

This is the page for the 3d-Printers in the Pixelbar.

Ender 5

Owner: Pixelbar

Warden: Sir 16-Bit

Expert Advisor: FPoison


Instructions

Startup:

  • do auto z-level
  • check tramming (paper between nozzle and bed)

Other instructions:

  • Start print from octoprint (SD card does not work)
  • PETG may only be printed on the bare steel side of the buildplate


Todo

  • install pi
  • testprint