Archive:3D-Printing: Difference between revisions
(Created page with " This is the page for using the 3d-Printers in the Pixelbar. = Printers = == Ender 5 == 200px|thumb|right|The Ender 5 Owner: Pixelbar Warden: Sir 16-Bit Expert Advisor: FPoison === Mods === [a lot] === Instructions === Startup: * do auto z-level * check tramming (paper between nozzle and bed) * Use profile from wiki Other instructions: * Start print from octoprint (SD card does not work) * PETG may only be printed on the bare ste...") Tag: wikieditor |
No edit summary Tags: wikieditor visualeditor-switched |
||
| Line 34: | Line 34: | ||
* testprint | * testprint | ||
* Upload profiles to Wiki | * Upload profiles to Wiki | ||
Latest revision as of 20:04, 3 February 2024
This is the page for using the 3d-Printers in the Pixelbar.
Printers[edit]
Ender 5[edit]
Owner: Pixelbar
Warden: Sir 16-Bit
Expert Advisor: FPoison
Mods[edit]
[a lot]
Instructions[edit]
Startup:
- do auto z-level
- check tramming (paper between nozzle and bed)
- Use profile from wiki
Other instructions:
- Start print from octoprint (SD card does not work)
- PETG may only be printed on the bare steel side of the buildplate
Todo[edit]
- install pi
- testprint
- Upload profiles to Wiki