Archive:3D-Printing

From Pixelbar
Revision as of 20:03, 3 February 2024 by NinjaLikesCheez (talk | contribs) (Created page with " This is the page for using the 3d-Printers in the Pixelbar. = Printers = == Ender 5 == 200px|thumb|right|The Ender 5 Owner: Pixelbar Warden: Sir 16-Bit Expert Advisor: FPoison === Mods === [a lot] === Instructions === Startup: * do auto z-level * check tramming (paper between nozzle and bed) * Use profile from wiki Other instructions: * Start print from octoprint (SD card does not work) * PETG may only be printed on the bare ste...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)


This is the page for using the 3d-Printers in the Pixelbar.

Printers

Ender 5

File:Ender5 pixelbar.jpg
The Ender 5

Owner: Pixelbar

Warden: Sir 16-Bit

Expert Advisor: FPoison


Mods

[a lot]

Instructions

Startup:

  • do auto z-level
  • check tramming (paper between nozzle and bed)
  • Use profile from wiki

Other instructions:

  • Start print from octoprint (SD card does not work)
  • PETG may only be printed on the bare steel side of the buildplate


Todo

  • install pi
  • testprint
  • Upload profiles to Wiki
Retrieved from "https://wiki.pixelbar.nl/index.php?title=Archive:3D-Printing&oldid=16"