Difference between revisions of "3D-Printing"
Jump to navigation
Jump to search
Sir 16-bit (talk | contribs) |
Sir 16-bit (talk | contribs) |
||
(3 intermediate revisions by the same user not shown) | |||
Line 1: | Line 1: | ||
− | |||
+ | |||
+ | This is the page for using the 3d-Printers in the Pixelbar. | ||
+ | |||
+ | = Printers = | ||
== Ender 5 == | == Ender 5 == | ||
− | [[File:ender5_pixelbar. | + | [[File:ender5_pixelbar.jpg|200px|thumb|right|The Ender 5]] |
Owner: Pixelbar | Owner: Pixelbar | ||
Line 11: | Line 14: | ||
Expert Advisor: FPoison | Expert Advisor: FPoison | ||
+ | |||
+ | === Mods === | ||
+ | [a lot] | ||
=== Instructions === | === Instructions === | ||
Line 17: | Line 23: | ||
* do auto z-level | * do auto z-level | ||
* check tramming (paper between nozzle and bed) | * check tramming (paper between nozzle and bed) | ||
+ | * Use profile from wiki | ||
Other instructions: | Other instructions: | ||
Line 26: | Line 33: | ||
* install pi | * install pi | ||
* testprint | * testprint | ||
+ | * Upload profiles to Wiki | ||
+ | |||
+ | |||
+ | [[Category:2022 | {{#explode: {{PAGENAME}}|:|1}} ]] | ||
+ | [[Category:Community | {{#explode: {{PAGENAME}}|:|1}} ]] |
Latest revision as of 12:05, 25 February 2022
This is the page for using the 3d-Printers in the Pixelbar.
Printers
Ender 5
Owner: Pixelbar
Warden: Sir 16-Bit
Expert Advisor: FPoison
Mods
[a lot]
Instructions
Startup:
- do auto z-level
- check tramming (paper between nozzle and bed)
- Use profile from wiki
Other instructions:
- Start print from octoprint (SD card does not work)
- PETG may only be printed on the bare steel side of the buildplate
Todo
- install pi
- testprint
- Upload profiles to Wiki